For Wireless Network Users

Connecting the Brother machine to the wireless network

9

Configure the wireless

settings using the

automatic wireless mode

a Confirm your WLAN access point/router has the Wi-Fi Protected Setup or AOSS™ symbol as shown below.

b Place the Brother machine within range of your Wi-Fi Protected Setup or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your access point/router.

c On your machine, press + or - to choose Network and press OK.

Press + or - to choose WLAN and press OK. Press + or - to choose WPS/AOSS and press OK.

When WLAN Enable? is displayed, press + to accept. This will start the wireless setup wizard.

Otherwise press Cancel to exit from the wireless setup wizard.

When Press Key on rtr appears, press the Wi-Fi Protected Setup or AOSS™ button on your WLAN access point/router. See the user’s guide for your WLAN access point/router for instructions. And then press +.

This feature will automatically detect which mode (Wi-Fi Protected Setup or AOSS™) your access point/router uses to configure your machine.

Note

If your WLAN access point/router supports Wi-Fi Protected Setup (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi Protected Setup in the Network User's Guide.

d A connection result message appears on the LCD and a WLAN report will automatically be printed.

If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 20.

Wireless setup is now complete. A four level indicator at the right of your machine’s LCD will show the wireless signal strength of your access point/router.

To install the printer driver, continue to step 10.

For Windows® Users:

Now go to

page 23

For Macintosh Users:

Now go to

page 24

18