For Wireless Network Users
9 | Configure the wireless |
settings (typical Wireless | |
Setup in infrastructure |
mode)
IMPORTANT
You must have the wireless settings you wrote down for your network in step 8 on page 17 before you proceed.
a On your machine, press + or - to choose Network and press OK.
Press + or - to choose WLAN and press OK. Press + or - to choose Setup Wizard and press OK.
When WLAN Enable? is displayed, press + to accept. This will start the wireless setup wizard.
Otherwise press Cancel to exit from the wireless setup wizard.
b The machine will search for available SSIDs. If a list of SSIDs is displayed, use the + or - key to choose the SSID you wrote down in step 8 on page 17, then press OK.
If you are using an authentication and encryption method that requires a Network Key, go to c.
If your authentication method is Open System and your encryption mode is None, go to e.
If your WLAN access point/router supports
Note
•It will take several seconds to display a list of available SSIDs.
•If a list of SSIDs is not displayed, make sure your access point is on. Move your machine
closer to the access point and try starting from a again.
If you use your machine in an IEEE 802.1x supported wireless network, see Using IEEE 802.1x authentication in the Network User's Guide.
If your access point is set to not broadcast the SSID you will have to manually add the SSID name. For details, see Configuring your machine when the SSID is not broadcast in the Network User's Guide.
c Enter the Network Key you wrote down in step 8 on page 17.
To enter a letter or number, hold down or repeatedly press the + or - key until the letter you want appears, and then press OK.
To delete the letters you have entered, press the Back key.
For more information, see Entering Text for Wireless Settings on page 22.
Press OK when you have entered all the characters, then press OK for Yes to apply your settings. Go to d.
d Your machine will now try to connect to your wireless network using the information you have entered.
e A connection result message appears on the LCD and a WLAN report will automatically be printed.
If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 20.
Wireless setup is now complete. A four level indicator at the right of your machine’s LCD will show the wireless signal strength of your access point/router.
To install the printer driver, continue to step 10.
For Windows® Users: | Wireless | Windows® | |
|
| ||
Now go to |
|
| |
|
| ||
For Macintosh Users: | Network |
| |
Macintosh | |||
Now go to | |||
|
| ||
|
|
19