Brother 285C, 885-U22 operation manual Below the bobbin winder seat Thread properly

————————————————————————————————————————————————————

Symptom	Probable Cause	Remedy	Reference
While winding the
bobbin, the bobbin	You have not wound the bobbin	After removing the thread wound
thread was wound		below the bobbin winder seat,	page 151
	thread properly.
below the bobbin		wind the bobbin correctly.
winder seat.
	The thread is not passed through the	Correctly pass the thread through
	bobbin-winding thread guide		page 24
		the bobbin-winding thread guide.
	correctly.
Bobbin thread does
		Move the sewing speed controller
not wind neatly on	Bobbin spins slowly.	to the right (so that the speed will	page 25
the bobbin.		be fast).
	The thread that was pulled out was	Wind the thread that was pulled
	not wound onto the bobbin	off round the bobbin five or six	page 25
	correctly.	times clockwise.
Fabric being sewn	Thread is tangled below the needle	Lift up the fabric and cut the
with the machine		threads below it, and clean the	page 148
	plate.
cannot be removed.		race.
The fabric feeds in		Contact your dealer or the nearest		4
the opposite	The feed mechanism is damaged.		–
		authorized service center.
direction.
The upper thread	The bobbin thread is incorrectly	Correctly install the bobbin	page
has tightened up.	installed.	thread.	26, 144
The thread is			page
tangled on the	You have not threaded the upper	Correct the upper threading.
wrong side of the	thread properly.		28, 145
fabric.

Troubleshooting 157