Brother CS-770 operation manual Replacing the Presser Foot, Replacing the presser foot

KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

REPLACING THE PRESSER FOOT

CAUTION

●Always turn off the power before you change the presser foot. If you leave the power on and step on the controller, the machine will start and you may be injured.

●Always use the correct presser foot for the stitch pattern you have chosen. If you use the wrong presser foot, the needle may strike the presser foot and bend or break, and may cause injury.

●Only use presser feet that have been designed to be used with this machine. Using other any presser feet may cause an accident or injury.

Replacing the presser foot

Replace the presser foot as described below.

aRaise the needle by turning the handwheel toward you (counterclockwise) so that the

mark on the wheel points up. (With models

equipped with (needle position button), raise the needle by pressing once or twice.)

or

a Mark b Needle position button

bIfturntheitsewingoff. machine has been turned on,

CAUTION

●Before replacing the presser foot, be sure to turn off the sewing machine, otherwise injuries may occur if the foot controller or the start/stop button is accidentally pressed and the machine starts sewing.

cRaise the presser foot lever.

dPress the black button at the back of the presser foot holder to release the presser foot.

aBlack button

bPresser foot holder

ePlace a different presser foot below the holder so that the presser foot pin is aligned with the shank in the holder.

Position the presser foot so the letter indicating the presser foot type (J, A, etc.) is positioned to be read.

aPresser foot holder

bShank

cPin

Note

●The presser foot to be used with each stitch appears in the LCD. To select a stitch, refer to “Selecting stitching” (page 27).

aPresser foot lever

24