5
Setting Up
the Machine
Windows®
Mac OS®
9.1 - 9.2
Mac OS® X
6Press down on the ink cartridge until the
hook snaps over it, taking care to match the
slot colour (A) with the cartridge colour (B),
as shown in the diagram below.
7Lift the scanner cover to release the lock.
Gently push the scanner cover support
down and close the scanner cover.
The machine will clean the ink tube system
for use for the first time. This process will
occur only once, the first time ink cartridges
are installed. The cleani ng process will last
approximately four minut es.
The LCD shows:
1After the cleaning cycle is finished, the LCD
shows:
2Make sure the paper is loaded in the paper
tray.
Press Colour Start.
3The machine starts printing the PRINT
QUALITY CHECK SHEET (only during
initial ink cartridge installation).
Avoid touching the printed surface
of the paper immediately after
printing, the surface may not be
completely dry and may stain your
fingers.
4If all lines are clear and visible, the qu ality is
acceptable. Press ▲ (Yes). If you can see
missing short lines, press ▼ (No) to begin
the color cleaning process and then follow
prompts on the LCD.
5After cleaning is finished, press
Colour Start. The machine starts print ing
the PRINT QUALITY CHECK SHEET again
and goes back to step 3.
If Install shows on the LCD after you
install the ink cartridges, check to make sure
the ink cartridges are installed correctly.
Preparing System
Approx 4 Minutes
(B)
(A)
OK
OK
OK
7Print Quality Check
Set Paper and
Press Start
Print Quality Check
1. Check the quality of the four-color blocks formed by the short lines.
2. If all the short lines are clear and visible, the quality is acceptable. the quality is acceptable.
Select (Yes). If you can see missing short lines, select (No) to begin the color cleaning process
and follow the prompts on the LCD.
OK Poor