Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)

For Touchscreen models

a Press MENU.

b Press Network.

c Press WLAN.

d Press SES/WPS/AOSS.

3

 

This feature will automatically detect which mode (SecureEasySetup™, Wi-Fi Protected Setup™ or

 

AOSS™) your access point uses to configure your machine.

 

Note

If your wireless access point supports Wi-Fi Protected Setup™ (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi Protected Setup™ on page 44.

e When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard.

To cancel, press Stop/Exit.

f The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ for 2 minutes.

g Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction manual that came with your access point.

h If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network.

If the LCD shows Connection Error, a session overlap has been detected. The machine has detected more than one access point/router on your network with the SecureEasySetup™ mode, the WiFi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only one access point/router has the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or the AOSS™ mode enabled and try starting from d again.

If the LCD shows No Access Point, the machine has not detected your access point/router on your network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Move the machine closer to your access point/router and try starting from d again.

If the LCD shows Connection Fail, the machine has not successfully connected to your access point/router. Try starting from d again. If the same message is indicated again, reset the machine back to the default factory settings and try again. (For resetting, see Restoring the network settings to factory default on page 114.)

42