Configuring your machine for a wireless network (Not available for
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows | Connection status | Action |
Setting WLAN | Searching or accessing the access point, |
|
and downloading settings from the access | — | |
| point. |
|
Connecting SES |
| 3 | ||
Connecting WPS | Connecting to the access point. | — | ||
Connecting AOSS |
|
|
| |
Connected | Connection succeeded. | — |
| |
|
| Check that only one router or access | ||
Connection Error |
| point has the SecureEasySetup™ | ||
Session overlap has been detected. | mode, the | |||
|
| mode or AOSS™ mode enabled and try | ||
|
| starting from step d again. | ||
|
|
|
| |
No Access Point |
| Move the machine closer to your | ||
The access point detection failed. | access point/router and try starting from | |||
|
| step d again. | ||
|
|
|
| |
|
| Try starting from step d again. | ||
Connection Fail | Connection failed. | If the same message reappears, | ||
reset the machine back to the | ||||
|
| |||
|
| factory settings and try again. | ||
Note
•If you encounter a problem during setup, temporarily place your machine closer to the wireless access point, and go back to step d.
•You can also manually configure the wireless settings following the steps starting at step a on page 34.
i Press 
.
(Windows®)
You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please choose Install
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please choose Start Here OSX from the
43