Press WPS w/PIN Code, and then press WPS w/PIN Code.
Press MENU. Press Network. Press WLAN.

Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)

For Touchscreen models

a b

c

d3

e When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard.

To cancel, press Stop/Exit.

f The LCD will show an 8 digit PIN and the machine starts searching for an access point for 5 minutes.

g Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar 1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in f to the Registrar and follow the on-screen instructions.

1The Registrar is normally the access point/router.

Note

The setting page is different, depending on the brand of access point/router. See the instruction manual that came with your access point/router.

If you are using your Windows Vista® computer as a Registrar, follow the next instructions.

Note

To use a Windows Vista® computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your access point/router.

1Click and then Network.

2Click Add a wireless device.

3Choose your machine and click Next.

4Input the PIN from the printed page and then click Next.

5Choose your network that you want to connect to, and then click Next.

6Click Close.

46