Brother S-7200A 4-5. Test operation (Operating the treadle)

S-7200A

4. INSTALLATION

4-5. Test operation (Operating the treadle)

CAUTION

Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in

personal injury or damage to the machine.

Press the ON power switch (1).

The power indicator (2) will illuminate.

NOTE: When turning the power switch on for the first time

The treadle and the operation panel will not operate for

approximately four seconds after the power switch is

turned on.

After approximately 4 seconds, “iniT rPM” (speed

initialization) or “iniT ALL” (full initialization) will be

displayed on the operation panel. After “iniT rPM” or “iniT

ALL” is displayed, the treadle can be operated. (The

operation panel will change to the stitch number display.)

This message will not appear the second and subsequent

times that the power switch is turned on.

1. Check that the machine sews at low speed when the

treadle (3) is gently pressed to position (B).

2. Then check that it sews at high speed when the treadle

(3) is gently pressed to position (C).

3. After pressing the treadle (3) forward, check that the

needle is lowered to the top of the needle plate when the

treadle (3) is returned to the neutral position (A). (when

needle down stopping has been set.)

4. If the treadle (3) is pressed to position (D), thread

trimming is carried out and the needle then rises above

the needle plate and stops.

2114M 2115M

2116M

2117M