Browning TG23F, TG41F, C41F A N G I N G T H E C O M B I N a T I O N, Y L O C K, I N T, R E S E a L

C H A N G I N G T H E C O M B I N A T I O N

Your combination of the S & G® Mechanical Lock is pre-set at the factory. Changing the combination will void your lock warranty. If you must change the combination for some reason, contact a certified locksmith to do this for you.

K E Y L O C K

The keylock in your combination dial is used to lock the dial only. This is a convenience feature that allows you to lock your dial so that it will not accidentally rotate and lock while you are moving items into or out of your safe. The keylock also allows you to lock the dial while the safe is in the locked position. This prevents the dial from being turned while the safe is locked.

To lock your dial with the key, turn the dial until the “0” is resting in the 12 o’clock position, where the black line is located on the top of your dial ring and turn the key clockwise in the key lock.

Should you lose your keys, replacement keys may be ordered with the serial number printed on the upper right-hand corner of the combination tag. Contact the Browning Consumer Department (page 22) to order additional keys. (Approximately $8 per key as of this owner’s manual printing.)

P A I N T

Painted exteriors should be cleaned with a damp soft cotton cloth only. Do not use solvents or any other chemicals to clean your safe’s painted surfaces. If you should scratch or chip the paint on your safe, a touch up bottle with brush is included inside your safe (not all models). This bottle should be adequate for most scratches incurred during installation. Touch up paint is also available by contacting Browning. However, due to increased regulations restricting the sending of paint through the mail, Browning has also provided the Delstar® paint numbers for the paint colors available on our standard safes.

Gloss Black	DAR 9000
Hunter Green Metallic	DAR 4108
Burgundy	DAR 74004
Sand Metallic	F1929
Black Cherry	Sherwin-Williams® 82128

If touch up paint is needed other than that supplied by Browning, you can get it at an automotive paint supplier.

important: The textured-finished safe paints are special formulas created by the manufacturer for Browning ProSteel safes and cannot be duplicated by an automotive paint store. These can be ordered by calling our consumer department at (800) 333-3288.

D O O R C L O S U R E A D J U S T M E N T

Browning ProSteel safes are shipped with molded door corner protectors installed between the door corner and the door frame. After removing the packaging from your safe, make sure to remove the protective corners and adjust the two door tension adjustment screws located inside of the door frame. The tension adjustment screws apply pressure against the locking bolts when the door is in the closed position. The tension adjustment screws should be adjusted until the door closes without play between the door and frame. Do not over-adjust the tension screws or your safe will not close. The locking bolts will hit the adjustment screws. A #3 Phillips screwdriver is required to adjust the tension screws.

F I R E S E A L

The black plastic strip attached to the edge of your safe door or frame is a fire seal that expands to seal the door when heated by a fire. If you live in an area with high humidity, you will not want your door to close tightly against this seal. Air must circulate through your safe or condensation will form on your firearms causing rust. Loosen the door just enough to allow some exchange of air. An electric dehumidifier is highly recommended if your average daily relative humidity is above 20 percent.

16 17