Bryan Boilers CLM-300-W-GI, CLM-150-S150-GI manual Quality Construction Features

Low initial cost, high operating efficiency deliver substantial return on investment

•True “flexible water tube” design guaranteed shock free

•Longer service life with superior performance

•Full five sq ft of heating surface per BHP

Quality Construction Features

G

LI

A. Heavy steel boiler frame, built and stamped	B
in accordance with the appropriate ASME
boiler code.
B. Large volume water leg downcomers pro-	D
mote rapid internal circulation, temperature
equalization and efficient heat transfer.	E
C. Bryan bent water tubes are flexible, individu-
ally replaceable without welding or rolling.
Never more than two tube configurations.

D. Boiler tube and furnace area access panel: heavy gauge steel casing with 2" high tem- perature ceramic fiber and insulation, bolted and tightly sealed to boiler frame.

C

A

J

F

K

H

E.Jacket access panels make the interior of the boiler easily accessible for service and inspection.

F.Heavy gauge steel boiler jacket with rust-resistant zinc coating and attractive enamel finish, insulated with 1½" fiberglass to insure exceptionally cool outer surface.

G.Minimum sized flue vent.

I.All controls, gauges, relief valve(s) are factory installed and wired and easily accessible for servicing.

J.Control panel: all controls installed and connected to terminal strip.

K.Water side or steam side interior accessible for clean- out and inspection, front and rear openings, upper and lower drums.

L.Steam boilers with extra large drum with high steam release area ensure stable water level and dry steam.

Bryan CLM Series Boilers Standard and Optional Equipment

STANDARD EQUIPMENT FURNISHED

Water Boiler

Combination thermometer and pres- sure gauge, ASME-rated boiler relief valve, water temperature control (240°F max. std.), high limit control, probe LWCO.

Steam Boiler

Steam pressure gauge, steam pres- sure control, combination low water cutoff and pump control, auxiliary low water cutoff with manual reset, high limit pressure control, ASME-rated boiler relief valve, water glass set.

Atmospheric equipment

Electronic combustion safety control, automatic operating gas valve, safety gas valve, pilot solenoid valve, electric

ignition assembly, main manual gas shut-off valve, pilot shut-off valve, pilot and main gas pressure regula- tors, barometric draft controller, all controls installed and wired standard voltage 120/1/60.

OPTIONAL EQUIPMENT:

1.Manual reset high limit control

2.Manual reset low water cutoff

3.Auxiliary low water cutoff (water)

4.Combination low water cutoff and feeder

5.Alarm bells or horns

6.UL, CUL, CSD-1, FM, IRI or other insurance approved control systems

7.Low fire start, Hi-Lo or modulation fire control

8.Indicating lights, as desired

9.Lead-lag systems for two or more boilers with or without outdoor reset control

10.Heat exchanger coils for domestic water

11.Special construction: left hand, Knocked Down

OPTIONAL

CONSTRUCTION:

Steam boiler

Optional construction to ASME Power Boiler Code requirements for pressure exceeding 150 psi to maximum of 300 psi design pressure.

Hot water boiler

Optional construction to ASME Power Boiler Code requirements for temperatures exceeding 240°F and/or pressure exceeding 160 psi to maxi- mum of 285°F operating and 300°F design temperature and 250 psi.

When ordering, please specify:

1.Boiler size

2.Supply and return temperatures required

3.Boiler relief valve setting

4.Type of fuel: natural or LP, BTU content, specific gravity and pressure available

5.Optional extra equip- ment or construction

6.Special approvals re- quired (UL, CUL, CSD-1, FM or IRI)

7.Altitude