ACCESS PANEL
FILTER ACCESS
PANEL*
*For accessory ®lter rack.
Fig. 5 Ð Filter Access Panel Ð Vertical Supply Shown
VIII. Electrical Controls and Wiring
Electrical controls are difficult to check without proper in- strumentation; therefore, if there are any discrepancies in the operating cycle, contact your dealer and request service.
IX. Refrigerant Circuit
The refrigerant circuit is difficult to check for leaks without the proper equipment; therefore, if inadequate cooling is sus- pected, contact your local dealer for service.
X. Combustion Area and Vent System
The combustion area and vent system should be inspected visually before each heating season. The normal accumula- tion of dirt, soot, rust, and scale can result in loss of effi- ciency and improper performance if allowed to build up.
CAUTION: If your unit makes an especially loud noise when the main burners are ignited, shut down the heat- ing section and call your dealer.
Proceed as follows to inspect the combustion area and power- venting system of your unit.
1.Turn off electrical power and gas supply to your unit.
2.Remove burner access panel. (See Fig. 1.)
3.Using a ¯ashlight, carefully inspect the burner areas for dirt, soot, rust, or scale. See Fig. 2.
CAUTION: If dirt, soot, rust, or scale accumulations are found, call your dealer and do not operate your heat- ing section.
4.When you have completed your inspection, follow the
5.Observe unit heating operation.
WARNING: Components in heat section may be hot after unit has been started up. When observing ¯ame, be careful not to get close to or touch heating compo- nents or serious personal injury may result.
Watch the burner ¯ame to see if it is bright blue. If you observe a suspected malfunction or if the burner ¯ames are not bright blue, call your dealer.
6. Replace burner access panel.
XI. Unit Panels
After performing any maintenance or service on the unit, be sure all panels are fastened securely in place to prevent rain from entering unit cabinet and to prevent disruption of the correct unit air¯ow pattern.
REGULAR DEALER MAINTENANCE
In addition to the type of routine maintenance you might be willing to perform, your unit should be inspected regularly by a properly trained service technician. An inspection (pref- erably each year, but at least every other year) should in- clude the following:
1.Inspection of all ¯ue product passages Ð including the burners, heat exchanger, and ¯ue collector box.
2.Inspection of all combustion- and
3.Close inspection of all gas pipes leading to and inside of your unit.
4.Inspection and, if required, cleaning of the condenser and evaporator coils.
5.Inspection and, if required, cleaning of the evaporator drain pan.
6.Inspection and cleaning of blower wheel housing and motor.
7.Inspection of all
8.Inspection of the unit base to ensure that no cracks, gaps, etc., exist which may cause a hazardous condition.
9.Inspection of the unit casing for signs of deterioration.
10.Inspection of all electrical wiring and components to assure proper connection.
11.Inspection for leaks in the refrigerant circuit. Pressure- check to determine appropriate refrigerant charge.
12.Inspection of compressor oil level.
13.Operational check of the unit to determine working con- ditions. Repair or adjustment should be made at this time.
Your servicing dealer may offer an economical service con- tract that covers seasonal inspections. Ask for further details.
Complete service instructions can be found in the unit Installation,
WARRANTIES
Units 582A and 583A have warranties located at the back of this book. Be sure to read the warranty carefully to deter- mine the coverage for your unit.
Ð7Ð
