Bryant 594D SPECIFICATIONS Continued, Unit Size - Series, 042-E, 048-E/F, 060-E, Electrical

SPECIFICATIONS Continued

UNIT SIZE - SERIES	042-E	048-E/F	060-E
OPERATING WT (Lb)	213	247	287
ELECTRICAL
Unit Volts—Hertz—Phase	208/230—60—1	208/230—60—1	208/230—60—1
Operating Voltage Range*	187—253	187—253	187—253
Compressor— Rated Load Amps	20.0	23.7/21.3	28.8
Locked Rotor Amps	104.0	129.0/137.0	169.0
Condenser Fan Motor—Full Load Amps	1.1	1.4	1.4
Min Unit Ampacity for Wire Sizing	26.1	31.0/28.0	37.4
Min Wire Size (60°C Copper) AWG†	10	8/10	8
Min Wire Size (75°C Copper) AWG†	10	10	8
Max Wire Length (60°C) (Ft)‡	96	71	104
Max Wire Length (75°C) (Ft)‡	91	68	99
Max Branch Circuit Fuse Size**	40	50/40	60
COMPRESSOR AND REFRIGERANT
Compressor—Manufacturer & Type		Copeland Scroll
Temperature & Current Protection		Internal Line Break
Refrigerant—R-22 Amount (Lb)	6.68	6.34	9.25
CONDENSER COIL AND FAN
Coil Face Area (Sq Ft)	15.2		18.3
Fins per In.—Rows—Circuits	25—1—3		25—1—4
Fan Motor—HP, Type, & RPM	1/5 PSC & 825	1/4 PSC & 1100
Volts—Hertz—Phase		208/230—60—1
Condenser Airflow (CFM)	3000	3300
OPTIONAL EQUIPMENT
Support Feet Kit		KSASF0101AAA
Coastal Filter		KAACF0201MED
Time-Delay Relay		KAATD0101TDR
Cycle Protector	KSACY0101AAA	Standard
Crankcase Heater		KAACH1201AAA
Start Assist—Capacitor/Relay Type	KSAHS1501AAA		KSAHS1601AAA
Start Assist—PTC Type		KAACS0201PTC
TXV Kit (RPB)	KAATX0501RPB	KAATX0601RPB	KAATX0701RPB
TXV Kits (Hard Shutoff)	KSATX0601HSO	KSATX0701HSO
Low-Pressure Switch		KAALP0101LPS
High-Pressure Switch		KSAHI0101HPS
Filter Drier		P502-8163S (RCD)
Evaporator Freeze Thermostat††		KAAFT0101AAA
Liquid-Line Solenoid Valve		KAALS0101LLS
Winter Start Control††		KAAWS0101AAA
Low-Ambient Kit		KSALA0201R22
Low-Ambient Controller		P251-0083 (RCD)
MotorMaster® Control‡‡		32LT660004 (RCD)
Ball Bearing Fan Motor	HC38GE231 (RCD)	HC40GE232 (RCD)
Thermostat, Auto Changeover,
Non-Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool		TSTATBBNAC01-B
Thermostat, Auto Changeover,
7-Day Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool		TSTATBBPAC01-B
Builder’s Thermostat, Manual
Changeover, Non-Programmable,
°F/°C, 1-Stage Heat, 1-Stage Cool		TSTATBBBAC01-B
Thermidistat™ Control—Programmable/
Non-Programmable Thermostat with
Humidity Control		TSTATBBPRH01-B
Outdoor Air Temperature Sensor		TSTATXXSEN01-B
Backplate for Non-Programmable
Thermostat		TSTATXXNBP01
Backplate for Builder’s Thermostat		TSTATXXBBP01
Backplate for Programmable Thermostat		TSTATXXPBP01
Thermostat Conversion Kit (4 to 5 wire)
— 10 Pack		TSTATXXCNV10

* Permissible limits of the voltage range at which the unit will operate satisfactorily. Operation outside these limits may result in unit failure. Copper wire must be used from service disconnect to unit.

† If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70).

The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article 336-26.

‡Length shown is as measured 1 way along wire path between unit and service panel for a voltage drop not to exceed 2 percent. All motors/compressors contain internal overload protection.

** Time-delay fuse.

†† Use with Low-Ambient Controller.

‡‡ Fan motor with ball bearings required.

—5—