Bryant 698B warranty Specifications, 024-A, 036-A, 048-A, 060-A

SPECIFICATIONS

UNIT SIZE-SERIES		024-A	036-A	048-A	060-A
OPERATING WEIGHT (Lb)		188	243	282	327
ELECTRICAL
Unit Volts—Hertz—Phase		208/230-60-1	208/230-60-1	208/230-60-1	208/230-60-1
Operating Voltage Range*		187-253	187-253	187-253	187-253
Compressor— Rated Load Amps		10.6	14.1	22.3	28.3
	Locked Rotor Amps	64.0	66.0	96.0	130.0
Condenser Fan Motor—Full Load Amps		0.5	0.84	1.1	1.1
Min Unit Ampacity for Wire Sizing		13.8	18.5	29.0	36.5
Min Wire Size (60°C Copper) AWG†		14	14	10	8
Min Wire Size (70°C Copper) AWG†		14	14	10	8
Max Wire Length (60°C) (Ft)‡		57	43	69	91
Max Wire Length (70°C) (Ft)‡		55	41	66	56
Max Branch Circuit Fuse Size**		20	30	45	60

COMPRESSOR AND REFRIGERANT
Compressor—	Manufacturer			Bristol
	Type			Reciprocating
Temperature and Current Protection			Internal Overload
Refrigerant—	Type		Puron® (R-410A)
	Amount (Lb)	6.1			13.9	15.3
			10.0
Metering Device			Puron TXV Balance Port Hard Shutoff
CONDENSER COIL AND FAN
Coil—Face Area (Sq Ft)		10.8	12.12		18.2	18.2
Fins per In.—Rows—Circuits		25-1-2	20-2-3		20-2-5	20-2-5
Fan Motor—HP and RPM (PSC Type)		1/15 and 825	1/8 and 825		1/5 and 825	1/5 and 825
Volts—Hertz—Phase				208/230-60-1
Condenser Airflow (CFM)		1500	2500		3000	3100
OPTIONAL EQUIPMENT
Support Feet			KSASF0101AAA
Coastal Filter			KAACF0801MED
Snow Stand		KHASS0106MPK			KHASS0206MPK
Thermostat, Auto Changeover,
Non-Programmable, °F/°C, 2-stage heat/
2-stage cool in AC mode, 3-stage heat/			TSTATBBN2S01-B
2-stage cool in HP mode
Thermostat, Auto Changeover,
7-Day Programmable, °F/°C, 2-stage heat/
2-stage cool in AC mode, 3-stage heat/			TSTATBBP2S01-B
2-stage cool in HP mode
Thermidistat Control, Programmable/Non-			TSTATBBPRH01-B
Programmable Thermostat with Humidity Control
Outdoor Air Temperature Sensor			TSTATXXSEN01-B
Backplate for Non-Programmable Thermostat			TSTATXXNBP01
Backplate for Programmable Thermostat			TSTATXXPBP01
Thermostat Conversion Kit (4 to 5 wire)—10 Pack			TSTATXXCNV10

* Permissible limits of the voltage range at which the unit will operate satisfactorily. Operation outside these limits may result in unit failure.

†If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70). The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article 336-26. If other than uncoated (non-plated), 60 or 75°C (140 or 167°F) insulation, copper wire (solid wire for 10 AWG and smaller, stranded wire for larger than 10 AWG) is used, consult applicable tables of the NEC (ANSI/NFPA 70).

‡Length shown is as measured 1 way along wire path between unit and service panel for a voltage drop not to exceed 2%. ** Time-delay fuse or circuit breaker.

NOTES: 1. Copper wire must be used from service disconnect to unit.

2.All motors and compressors contain internal overload protection.

3.This product may not be used in low-ambient applications below 55°F outdoor ambient.

—4—