B100 TWO CHANNEL POWER AMPLIFIER
analog audio input signals.
•In
LINE LEVEL ANALOG AUDIO OUTPUTS :
The Bryston B100 integrated amplifier comes equipped with 2 pairs of gold plated analog RCA jacks for out- puts: PREAMP OUT and RECORD OUT.
• PreAmp Out is normally connected, internally, via the Connected/Separate switch, to Power Amp In
• Record Out output is not affected by volume, balance or mute controls.
DIGITAL AUDIO INPUTS:
In the
Two TOSLINK optical inputs are selected by pressing the D3
Two SPDIF coaxial inputs can be connected to the
Note: Whatever digital input was previously selected in Digital Mode will be automatically reselected upon
See also the
HEADPHONE JACK:
There is a quarter inch headphone output jack available on the front panel of the Bryston B100 integrated amplifier. The headphone output is driven directly from the preamplifier section utilizing separate headphone buffers. Inserting the headphone jack mutes the loudspeakers automatically (indicated by the mute LED on the front panel turning red). The B100 Preamp Out is also muted.
You can adjust the volume setting of the headphones by using the volume control on the front of the B100 inte- grated amplifier. You may also utilize the remote control unit to adjust headphone volume. The headphones cannot be muted with the remote control unit or the front panel Mute. Only headphones with impedances of greater than 50 ohms should be used.
AUXILIARY IR INPUT:
This mono 1/8” (3mm) phone jack allows a direct connection to equipment whose remote control system pro- vides an output from their
LED STATUS INDICATORS:
CLIPPING: This LED (light emitting diode) will flash RED when the output waveform is clipped thus indicating an overload condition.
MUTE:Lights RED to indicate the outputs are muted..
POWER: GREEN indicates normal operation RED indicates Standby
Blinking RED/GREEN a fault or thermal overload problem in the unit.
2