B100 TWO CHANNEL POWER AMPLIFIER
INTRODUCTION:
Thank you for purchasing a Bryston B100 integrated amplifier. We are confident it will provide you with many years of musical enjoyment. We would welcome any suggestions or comments you may have regarding the operation of your Bryston amplifier.
In the unlikely event that your amplifier may require service Bryston recommends that you retain the original shipping box and packaging material for future use if required.
SETUP RECOMMENDATIONS:
You may place your B100 integrated amplifier in any convenient location. Make sure you position the ampli- fier to maintain a direct
The amplifier is powered up by engaging the power button located on the front panel of the B100 or by depressing the POWER button on the hand held remote control unit.. The B100 will
CONNECTIONS:
LOUDSPEAKERS:
Connect your loudspeakers, ensuring that the positive (red) and ground (black) terminals
SEPARATE PRE-AMP OUT & POWER AMP IN JACKS:
These two pair of RCA jacks allow for the independent use of the stereo amplifier section within a
WIRED (SERIAL DATA) REMOTE CONTROL:
There is one
CHASSIS GROUND:
A chassis ground thumb screw terminal is provided on the rear panel.
12 VOLT TRIGGER CONNECTOR:
These 12Vdc control outputs allow the B100 to exert on/off control over compatible equipment. See “REMOTE POWER CONTROL” for more information..
LINE LEVEL ANALOG AUDIO INPUTS :
The Bryston B100 integrated amplifier comes equipped with 8 pairs of gold plated analog RCA input con-
nectors: TV, CD,
• Power Amp In is normally connected, internally, to Pre Amp Out via the Connected/Separate slide switch located on the rear panel. When this switch is in the Separate position, however, any line level audio input can be used at the Power Amp Input jacks to drive the amplifier.
• In
1