Getting started | 5 |
|
|
Location
You need to place your BT Converse 2100 within 3 metres of a telephone socket so that the cable will reach. Your BT Converse 2100 can be wall mounted,
see ‘Wall mounting your phone’ on page 14.
Setting up
1. Plug the end of the telephone line cord into the telephone wall socket.
2.Check that the dialling Mode switch on the underside of the base is set to TB for tone dialling with timed break recall.
3.Fit the desk mounting plinth if required by positioning the plinth over the lugs and pushing it down into place, as shown by the blue arrows.
Your BT Converse 2100 is now ready for use.
WARNING
Do not place your BT Converse 2100 in the bathroom or other humid areas.
Other electrical equipment close to your Converse could have an adverse effect on call quality. If you experience buzzing during a call try moving the Converse away from any electrical equipment that may be nearby.
important
Only use the handset and line cord supplied or this product may not work.
Dialling mode
If connecting to a switchboard you may need to adjust the dialling mode setting to P or T using the Mode switch on the underside of the base.
If in doubt, please consult your service provider.
If you experience any problems, please visit www.bt.com/producthelp
