If the number you call is engaged, you can set your Converse 420 to dial a number repeatedly, saving you from continually having to press the Redial button.

1When you hear the engaged tone, press the Redial button and replace the handset, (or press the

Handsfree button).

The display shows BUSY.

10 seconds after the handset is replaced your Converse 420 automatically picks up the line, switches on the loudspeaker and redials the number.

If it is still engaged you need do nothing, your phone will wait for 45 seconds before repeating the procedure.

This will be repeated every 45 seconds up to a maximum of 15 times or until the call is answered.

2When your call is answered, you can speak to your caller by pressing

Handsfree or lift the handset or press the Headset button and speak.

Note

To cancel repeat dial before your call is answered, lift the handset or press the Handsfree button or press the Headset button.

Visual ring indicator

time with the ringing signal. Lift the handset to answer the call.

Message Waiting

indicator

When you have Voice mail messages, the Message Waiting indicator flashes at regular intervals.

Note

This feature works with Meridian switchboard only.

To adjust the ringer volume

Set the ringer volume switch on the underside of your Converse 420 to HI, LOW or OFF.

HI

LOW

OFF

RINGER

VOLUME

The incoming call light will flash with all three settings.

To change the

ringer tone

Set the ringer tone switch on the underside of your Converse 420 to the setting you want: R1 for a low pitch ring or R2 for a high pitch ring.

R1

R2

RINGER

To adjust your caller’s

speech volume

2The display shows VOLUME and the current volume level. Turn the Navigator Wheel clockwise to increase the volume or anti-clockwise to decrease it.

To store names and

numbers in the

directory

Your Converse 420 stores up to 75 names and phone numbers:

You can use the Navigator Wheel - or the keypad - to enter names and numbers. The Navigator Wheel also lets you scroll quickly through stored names and numbers.

Stored numbers can be up to 21 digits long and include , # and pause .

Directory entries are automatically stored in alphabetical order. Numbers without attached names are stored at the

beginning of the list.

`

The directory is pre-programmed with some BT Select Services numbers (see ‘Using Select Services’). These can be overwritten

if you wish.

1Press and hold the Directory button. Display shows STORE and EDIT.

STORE will be flashing.

Release the Directory button.

When you have an

During a call

1 Press the Volume button.

2 Press the button.

incoming call, the Visual ring indicator will flash in

Display shows the number

of entries stored in the

Page 5
Image 5
BT 420 manual During a call