Bunn 34025.0004A manual Electrical Requirements, Electrical HOOK-UP Models without power cord

34025.4 031312

ELECTRICAL REQUIREMENTS

WARNING - The brewer must be disconnected from the power source until specified in Initial Set-Up.

Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.

L2 RED

L2 RED

L2 RED

L2 RED

L2

WHITEWHITE

NEUTRAL NEUTRAL

N

L1 BLACK

L2

L1 BLACK

L1

WHITE

NEUTRAL

WHITE

NEUTRAL

N

L1 BLACK	L1 BLACK
GREEN	GREEN

L1

G GREEN

GREEN G

L1 BLACK

GREEN

L1 BLACK

L1

GREEN G

120 volt ac models	200, 208 and 230 volt ac models	120/208 & 120/240 volt ac models
Note: This electrical service consists	Note: This electrical service consists	Note: This electrical service consists
of 2 current carrying conductors (L1	of 2 current carrying conductors (L1	of 3 current carrying conductors
and Neutral) and a separate conduc-	and L2) and a separate conductor	(Neutral, L1 and L2) and a separate
tor for earth ground.	for earth ground.	conductor for earth ground.

ELECTRICAL HOOK-UP (Models without power cord)

CAUTION – Improper electrical installation will damage electronic components. Damage caused by incorrect electrical connections is not covered by warranty.

1.An electrician must provide electrical service as specified in conformance with all local, state and federal electrical codes.

2.Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

3.Remove the front panel beneath the sprayheads to gain access to the terminal block.

4.Feed the cord through the strain relief and connect it to the terminal block.

5.Connect the brewer to the power source and verify the voltage at the terminal block before proceeding. Re- place the front panel.

6.If plumbing is to be hooked up later be sure the brewer is disconnected from the power source. If plumbing has been hooked up, the brewer is ready for Initial Set-Up.

ELECTRICAL HOOK-UP (Models with power cord)

WARNING– If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with a special cord available from the manufacturer or its service agent in order to avoid a hazard. Improper electrical installation will damage electronic components. Damage caused by incorrect electrical connec- tions is not covered by warranty.

1.An electrician must provide electrical service as specified in conformance with all local, state and federal electrical codes.

2.Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

NOTE - The brewer is shipped without a plug on the power cord. Qualified service personnel must select and install the proper UL listed grounding type attachment plug specified on the rear of the brewer.

3.Install the specified plug on the attached power cord.

4.Remove the front panel beneath the sprayheads to gain access to the terminal block.

5.Connect the brewer to the power source and verify the voltage at the terminal block before proceeding.

6.If plumbing is to be hooked up later be sure the brewer is disconnected from the power source. If plumb- ing has been hooked up, the brewer is ready for Initial Set-Up.

WARNING – Electrical connections must be made as specified above. Failure to follow these instructions can result in personal injury, property or equipment damage.

Page 4