SERVICE (cont.)
MAIN POWER ON/OFF SWITCH
P1923 |
FIG. 15 MAIN POWER ON/OFF SWITCH |
Location: |
The main power switch is located inside the dis- penser on the right of the whipper motor mounting panel.
Test Procedure:
1.Disconnect the dispenser from the power source.
2.Disconnect the black wires from the main wiring harness.
3.With the switch in the ON (lower) position check for continuity between the center and the upper termi- nal. With the switch in the OFF (upper) position no continuity should be present between center and upper terminals.
If continuity is present as described, the main power switch is operating properly.
If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Disconnect the dispenser from the power source.
2.Open the dispenser door and remove the hopper assembly out the front of the dispenser.
3.Remove the four
4.Slowly lift the hopper support panel up and discon- nect the red/black and green wires from the hopper switch.
5.Remove the switch mounting nut on the front of the whipper motor mounting panel.
6.Remove switch with wires attached from the rear of the whipper motor mounting panel.
7.Remove the wires from the switch terminals and discard switch.
8.Connect the wires to the new switch, refer to Fig. 16.
9.Push new switch through hole in the whipper motor mounting panel and secure with face nut.
10.Connect the red/black and green wires to the hop- per switch. See Fig. 10 on page 17.
11.Install the hopper support panel to the auger motor mounting panel and the whipper motor mounting panel using the four
12.Install the hopper assembly.
BLK from Power |
|
Cord |
|
BLK from Main |
|
Harness |
|
FIG. 16 MAIN POWER ON/OFF | P1907 |
| |
SWITCH TERMINALS |
|
22 | 29793.1 021202 |
|
