BUNNEspress®
OPERATION
Model ES•1AF
BREWING
1.Place a pod in the filter holder.
2.Lock the filter holder into the group head. Make sure it is tight.
3.Place an empty cup in position. The factory settings are for an 8 oz cup.
NOTE- Install the cup tray, as shown in the operating controls illustration (Page 6). This can be used when brewing into shorter cups, or swung out of the way when using taller cups. The height may be adjusted by moving the slide up or down, as desired.
4.If brewing a milk based drink, place the milk supply hose in milk.
5.Press the button indicating your selection.
NOTE- If you press the wrong selection, or want to stop brewing at any time, simply press the “STOP” button or any button on the panel.
6. Carefully remove the cup after the flow has stopped.
WARNING - The milk supply hose and milk container must be refrigerated after use in compliance with state and local Health Codes.
7.Disconnect the milk supply hose from the frother assembly.
8.Place the milk supply hose into a separate storage container or secure it to the milk container being careful not to allow contamination by contact with other foods or the refrigeration storage compart- ment.
DISPENSING HOT WATER OR FROTHED/STEAMED MILK
1.Place an empty cup in position.
2.Press the button indicating your selection.
3.Press any button to stop the cycle.
CLEANING General
1.The use of a damp cloth rinsed in any mild,
2.Clean the gasket that seals the filter & group head, located under the group head. Ground coffee build- up on this gasket will result in a bad seal of the filter holder, and will leak brewed coffee onto the outside of the filter holder when brewing. This is why it is important to wipe excess coffee off of the rim of the filter prior to insertion of the group head.
3.Clean the drip tray components nightly. Remove the grate, wireform, drip tray and drain hose. Clean drain cup thoroughly. Wash the grate, wireform and drip tray thoroughly. Run clean water through the drain hose. Reinstall drain hose, drip tray, wireform and grate.
Filter Cup
1.Place the pressure test cup into the filter holder.
2.Put a teaspoon of any granular espresso cleaner or automatic dish washing detergent into the filter cup.
3.Lock the filter holder into the group head, as if you were brewing coffee.
4.Press the expresso brew button and repeat for four cycles.
5.Remove the filter holder from the group head.
6.Rinse the group head thoroughly by repeating step 4 a few times without a filter holder installed.
7.Remove the cup filter and filter support wire from the filter holder.
8.Use a damp cloth rinsed in any mild
9.Rinse all parts in hot water and reassemble. Insure your hands are clean before reassembling the filter holder.
10.Repeat steps 2 through 9 with the double cup filter.
(Revised January 1996)
8
