Bunn B10, GR10 manual General Information, NOTE - THE BREWER IS NOT READY TO PLUG IN See Page

GENERAL INFORMATION

NOTE - THE BREWER IS NOT READY TO PLUG IN

(See Page 6)

Improper installation will result in permanent damage and void the limited warranty. Read and follow the instructions on the next page.

•This brewer is designed to remain plugged in at all times (except during initial installation or when cleaning).

•A vacation switch is provided on the lower left side to completely shut off all electrical components when your plans take you away from home for three or more days. Safety features, designed into the BUNN®coffee brewer, make the daily use of this switch unnecessary.

•If the brewer has been shut off or unplugged, fill the tank with water and allow the water in the tank to heat to the proper temperature before using (about fifteen minutes or until the heating sound stops).

•Your BUNN® coffee brewer has a specially designed tank to keep the water at the proper temperature. This constant supply of hot water assures correctly brewed coffee in less than three minutes.

•The brewed coffee flows into the decanter where it is kept at serving temperature on the porcelain decanter warmer.The warmer is controlled by the lighted on/off switch on the front of the brewer.

NOTE- The warmer switch controls only the decanter warmer.

•While coffee is being brewed, the newest water in the tank is heated to the proper temperature and held until needed.

•When the brewer is not in operation,the flip-lid should be closed.If the lid is left open, water could drip from the sprayhead when cold water is poured into the top of the brewer.

•The decanter lid reduces coffee evaporation and temperature loss.

•Use CAUTION when dispensing hot water from the brewer.The water is approximately 50°F hotter than that available from your hot water faucet and is always available for other uses.

•The brewer is equipped with a 120 volt,3-prong,grounded cord set.The plug is provided with a round grounding pin.This is a safety feature and allows the plug to fit into a properly grounded outlet. If the plug does not fit into the outlet, contact an electrician to update your outlet. Do not attempt to bypass the safety aspect of this plug.

•The sprayhead may periodically become loose. Using extreme caution since it may be hot, retighten the sprayhead with your finger tips.

NOTE- A severe burn may result if the sprayhead become loose and falls off while brewing.

5