Bunn HG Why Bunn Brews Better, Programming Your Brewer, Phase Brew Vs. Typical Drip, set clock

WHY BUNN BREWS BETTER

PHASE BREW VS. TYPICAL DRIP

BUNN Phase Brew is different from any brewer you’ve used before. Unlike ordinary coffee makers, BUNN Phase Brew doesn’t ‘drip’ right away. In fact, it doesn’t drip at all. That’s because BUNN Heat & Release Technology heats all the water to the right temperature, then quickly releases it through our unique sprayhead for an optimal 4-minute brewing phase and amazing coffee flavor in just 10 minutes!

BUNN PHASE BREW VS. TYPICAL DRIP

6-minute heating phase heats

water to about 200˚F, the right temperature for hot, flavorful coffee that’s never bitter.

Water in the top tank is released through

our unique sprayhead – creating the turbulence needed to wet the grounds evenly and extract perfect flavor.

4-minute brewing phase,

the right time for rich, smooth coffee

that’s never bitter.

Brews at an inconsistent temperature.

If water’s too cold, flavor can get left behind. If water’s too hot, coffee can taste bitter.

Drips water slowly over the grounds, so there’s not enough turbulence to wet all the grounds evenly. Some grounds are over-extracted making coffee taste bitter.

Heats water during the brew cycle,

dripping it slowly onto grounds.

The longer brew cycle makes coffee taste bitter.

PROGRAMMING YOUR BREWER

note: You must set the clock to use the brewer and the optional Auto-Start function. Remember to reset the clock for time changes and power outages.

set clock

1. Plug 3-prong power cord into standard electrical outlet.

2.Display will flash until clock is set.

3.Press Clock button.

4.Set time using Hour and Minute buttons. Numbers scroll forward only. Take care to select correct AM/PM time.

5.Press Clock button again to lock in time.

auto-start (optional)

1. Place BUNN coffee filter and coffee grounds into the brew funnel and slide into the funnel guides.

2.Fill brewer with 20 – 40 oz. of water and place carafe on base of brewer (failure to follow steps 1 and 2 may result in property damage).

3.Press Auto-Start button. Hour and Minute buttons will light up, time will flash on digital display.

4.Set time using Hour and Minute buttons. Numbers scroll forward only. Stop at desired Auto-Start time. Take care to select correct AM/PM time.

5.When desired brewing time is on the digital display, it will be set and Auto-Start will activate in 10 seconds. Once activated,

Auto-Start button will illuminate red. Do not press the button again as it will cancel your selected Auto-Start time.

6.To check your Auto-Start setting at any time, press the Auto-Start button and the digital display will flash the programmed time. The flashing time will remain the set time unless you change it. After 10 seconds with no buttons pushed, the Auto-Start button will illuminate and Auto-Start is set.

7.The Auto-Start function must be activated each time you want to pre- schedule a brew. If the Auto-Start button is not illuminated, the Auto-Start function is not activated.

8.To cancel a programmed Auto-Start, press the Auto-Start button twice.

35