Burley Nomad, Flatbed manual Solid Axle Adapter Installation

Solid Axle Adapter Installation

Remove non-drive (left) side axle nut and retain. If your hub uses non-turn washers, these should remain on the axle. Check exposed axle length by placing Adapter against the dropout (or non-turn washer, if present). If the axle extends beyond the last band, add one or two of the provided washers until the axle does not extend beyond the last band.





Axle too long: add washer

Thread on the Adapter and tighten to 30 N·m (22 ft·lb) using a 6mm hex key. Do not over tighten, as this can

damage the Adapter. Install Burley standard hitch onto the Adapter and secure using the axle nut removed earlier. Tighten to 20 N·m (15 ft·lb).

Refer to your Burley trailer manual for information on using your Burley hitch.

Eugene, OR USA

PH 541.687.1644 800.423.8445 FAX 541.687.0436 burley@burley.com : burley.com

Hitch Alt Adapter Manual: RTFM: Rev 07.2011