Installing the
Module
x600 Layer 3 Gigabit Ethernet Switch Installation Guide
To install the
1. Remove the module from the shipping package.
Note
Store the packaging material in a safe location. You must use the original shipping material if you need to return the unit to Allied Telesis.
2.Remove the blank panel from the expansion slot on the rear panel of the switch by loosening the two captive screws on the panel with a
1241 |
Figure 35. Removing the Blank Panel from the Expansion Slot
Note
All X600 Series Layer 3 Switch models are shipped from the factory with a Blank Panel installed in the rear panel Expansion Slot except for the
Note
Do not remove the blank panel from the chassis until you are ready to install a module. An open slot allows dust to enter the unit and reduces proper airflow and cooling.
3.Align the edges of
73