Allied Telesis x600-24Ts-POE manual VCS Stacking Module

Chapter 1: Overview

VCS Stacking Module

A Virtual Chassis Stack (VCS) is a group of x600 Layer 3 Gigabit Ethernet Series switches with a VCS Stacking module installed in each switch. The VCS Stacking module with its two full-duplex, 12 Gbps stacking ports, unifies the individual switches into a single, logical unit so that the network operations of the devices encompass all of the Gigabit Ethernet ports. This can simplify network management and augment network bandwidth. Figure 22 shows the VCS Stacking Module (AT-StackXG).

AT-StackXG

STACK PORT 1 STACK PORT 2

Figure 22. VCS Stacking Module (AT-StackXG)

Note

The x600-24/Ts-POE has two permanent stacking ports installed on its rear panel. Therefore, the VCS Stacking module is not required for this switch.

Refer to “VC Stacking Module Installation” on page 72 for the AT-StackXG module installation instructions. For further information on stacking, refer to the Allied Telesis Inc. website (www.alliedtelesis.com) for the Overview of Virtual Chassis Stacking (VCS) and the Virtual Chassis Stacking section of the AW+ Software Reference for x600 Series Switches.

46