Allied Telesis x600-24Ts-POE manual Software Reference

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

Note

Do not cable AT-StackXG module until you have prepared the switch’s Alliedware Plus Operating System software on the x600 Series Switches as explained in the x600 series AlliedWare Plus

5.3.1Software Reference.

5.Remove the plastic protector from the connector at one end of the stacking cable.

1244

Figure 38. Removing the Plastic Protector

6.Connect the cable to either Stack Port 1 or Stack Port 2 on the stacking module and secure by tightening the two captive thumbscrews.

7.Remove the plastic protector from the connector at the other end of the stacking cable and connect it to a Stack Port on the stacking module in the next switch of the stack. A stacking cable must crossover and connect to a different port on the next stacking module. Stack Port 1 on a module must connect to Stack Port 2 on the next module.

Caution

Do not connect two Stack Port 1 ports or Stack Port 2 ports together.

75