Chapter 4: Cabling the Network Ports
Powering on a Switch
To power on a switch, perform the following procedure:
1.Position the power cord retaining clip in the up position, as shown in Figure 45.
100- |
|
240VAC | |
| ~ |
Figure 45. Power Cord Retaining Clip in the Up Position
2.Plug the power cord into the AC power connector on the rear panel of the unit (see Figure 46).
Warning: Power cord is used as a disconnection device. To de- energize equipment, disconnect the power cord. E3
| |
C | |
| ~ |
Figure 46. Connecting the AC Power Cord
86
