MAINTENANCE
MAINTENANCE
Valve Reassembly
1.Examine all parts for wear and damage and replace if necessary.
2.Lubricate all
3.Lubricate all detent and spring centering parts with a light coat of grease before assembling.
4.Reassemble all parts in reverse order of disassembly.
Note: Use Locktite 222 or equivalent when installing detent retainers (18 & 24).
Relief Valve, Load Check Plugs and Power Beyond Sleeve
Note: Relief valve (3), load check plugs (40) and power beyond sleeve (2) may be removed separately to clean inspect or replace parts without removing valve spools.
Note: If repairing or replacing relief valve (3), torque larger hex nut (relief body) to
Replacing Handle Parts
If replacing damaged handle parts, cleans threads with loctite primer and install using loctite 242. Torque parts as shown in Illustration.
Storage
Never crawl under or allow children to play around or on a loader that is disconnected from the tractor. The loader could fall crushing a person resulting in serious injury or death.
Do not remove the attachment from the loader when the loader is disconnected from the tractor. The attachment stabilizes the loader. If the attachment is removed, the loader will fall and could result in serious injury.
Only disconnect and store the loader on firm flat ground. Make sure the loader stands are properly installed and rest on firm ground or support blocks. If the stands sink or fail, the loader could fall causing serious injury.
NOTE: When loader hydraulics are disconnected from tractor, the tractor hydraulic circuit must be completed. Failure to do so will result in tractor hydraulic pump damage.
1947/2047 01/11 | Maintenance Section |
© 2011 Alamo Group Inc.
