Bush Hog GT 48 manual Optional Front Roller, INSTALLATIO N Figure, Optional Rear Roller

4-3 OPTIONAL FRONT ROLLER	Figure 4-5
INSTALLATION (Figure 4-4 )	Bumper Guard
Bolt rollers to deck front lip placing back plate on
opposite side of deck lip. Bolts should be installed
with head to underside of cutter.
4-4 OPTIONAL REAR ROLLER
INSTALLATION (Figure 4-4)
Bolt roller to rear deck band placing back plate to
underside of deck. Bolts should be installed with
head to underside of cutter.
4-5 OPTIONAL BUMPER GUARD	Figure 4-6 Offset Tongue
INSTALLATION (Figure 4-5)
Using bumper as a template, mark and drill 7/16”			Outer Lug For
			Offset Tongue
holes through side of deck. Bolt bumper to deck as
shown with heads of bolts to the underside of deck.
4-6 OPTIONAL OFFSET TONGUE	Leveling Rod
INSTALLATION (Figure 4-6)
Position mounting bracket along front edge of		3/8 x 1”
deck as shown and mark hole locations. Drill 7/16”
		Bolts
holes through top and side of deck. Attach bracket to	1/2 x 1-1/4”
deck with bolts provided. Attach tongue to bracket	Bolt
and deck lug. The leveling rod must be moved from
the center pull location to the outer lug on the exle	Offset	Mounting
assembly. Connect leveling rod between tongue lug	Tongue
and axle lug with threaded end to the rear. Nuts on			Bracket
tongue and leveling rod should be snug, not tight, to			1/2 x 1-1/4”
allow tongue and leveling rod to pivot.	3/8” Locknuts		Bolt
	1/2” Locknut
		Rear Roller Assembly
Figure 4-4
Front and Rear Roller Installation
Front Roller Assemblies
	17