Bush Hog RTS manual 2-2OFFSETTING TILLER

H. Using cut off section of shield as a guide, cut shaft the same amount. (Figure 2-4)

Figure 2-4

2-2 OFFSETTING TILLER

The tillers may be offset to the right up to 6 inches on Model RTS40, 12 inches on Models RTS50 and RTS60, and 18-1/4 inches on Model RTS74. Adjust as follows:

A. Loosen U-bolts securing hitch lugs and gearbox stand to tiller frame.

B. Slide hitch lugs and gearbox to desired position maintaining the distance shown in Figure 2-6. An addi- tional 4-1/2 inches of offset can be obtained on the RTS40 and RTS50 by reversing hitch lugs as shown in Figure 2-7.

C. Tighten U-bolts.

I. Repeat steps “G” and “H” to other driveline section.

J. Deburr ends of driveline sections and clean away all chips and fillings. (Figure 2-5)

Figure 2-5

Figure 2-6 Hitch Lug Dimension

Clamp
Bolts
Frame	Gearbox	Hitch Pin
	Input Shaft	Brackets
	26-7/8”

K. Apply multi-purpose grease to inside of outer (female) driveline section. Assemble driveline and install on tractor and tiller. Pull on each driveline section to be sure yokes lock into place. Make cer- tain driveline shielding is in place and in good condi-

tion.

L. Adjust lower lift arm to level tiller right to left. Refer to tractor operator’s manual for instructions.

M. Adjust top link of tractor 3-point hitch to level tiller front to rear.

N. Set up tractor stabilizer bars, sway blocks, or equivalent to prevent implement side sway.

Figure 2-7 Alternate Hitch Lug Mounting

26-7/8”

8