4)Utilizing the 1.5mm Allen wrench, re-tighten the zero stop set screws inside the black inner locking cap (Fig. 5). The screws should be tightened to approximately 1.5-2 inch pounds. Do not over-tighten as this will cause damage to the screws.
5)Push the inner cap to its “down” position (Fig. 6). Replace the turret knob onto the turret by aligning the splines in the turret cap and the turret (Fig. 7). Once the cap is properly seated (Fig. 8) insure that the rubber o-ring is in place replace cap screw and tighten, finger tight with a coin or until snug with a screw driver (Fig. 9).
6)You are now ready to re-zero your weapon. Once you have achieved proper zero, refer back to the steps for setting the zero stop on pg. 7.
Fig. 5
