MOUNTING YOUR FIRST STRIKE REFLEX SIGHT
•Any Weaver or Picatinny style base is suitable for mounting the First Strike. Make sure the base you use is manufactured specifically for your pistol, rifle or shotgun. Be sure the base is properly installed and securely fastened according to the manufacturer’s instructions for your safety.
•There is no set eye relief for this sight, therefore, you should provide at least three inches of clearance between the end of the sight and your eye when in the shooting position.
•Loosen the hex bolt on the mount of the sight (C) using the large hex wrench (L). Position the mount on your base rail so that the crossbolt engages a slot. Tighten the hex bolt.
ZEROING YOUR FIRST STRIKE REFLEX SIGHT
Note: the following should be done at an approved range or other safe area. Eye and ear protection is recommended.
The First Strike scope has an integrated photocell (A), which automatically activates the unit when the protective lens cover (H) is removed, so there is no power switch. When you are finished using the scope, simply replace the cover to turn the power off again. Brightness of the 5 moa red dot is also automatically regulated by the photocell, based on the level of ambient light.
6
