Bushnell 960040 instruction manual Establish RF Connection with Main Unit

-After setting your home location, the weather forecast data for your
home city will be updated on your 4-Day Forecast program window
automatically via the Internet. You may click UPDATE FORECAST
anytime to manually update the forecast display on the program.
-You may set up to four additional cities by clicking on the respective
tab and selecting “Set Location”. Note that only your home location
will be updated on the main unit.
NOTE: Refer to the “TROUBLESHOOTING” section if you have
problem displaying the 4-day forecast information in the 4-Day
Forecast program window.
ESTABLISH RF CONNECTION WITH MAIN UNIT
-Before setting up the wireless RF (radio frequency) connection
between the USB transmitter and main unit, please ensure that you
have successfully received the forecast data in the 4-Day Forecast
program window for your home city.
-Keep the USB transmitter & main unit away as much as possible
from large metal objects & potential sources of interference such as
PC monitors, mobile phones, appliances, TV etc. It is recommended to
start with a short distance (about 2 feet or less) between the two units
for the initial RF setup. Once the RF connection is established, you
may place the main unit anywhere within the effective transmission
range from the transmitter (no greater than a maximum distance of
approximately 330 feet apart in an open area). Shorten the distance if
necessary for best reception.
-To search for RF signal from a new USB transmitter, press [PC
SEARCH] button on the main unit repeatedly until the RF icon
flashes.
-Press [TRANSMIT] button on the USB transmitter to enforce
transmitting RF weather data to the main unit
-Once the RF connection is established between the main unit & USB
transmitter, the full strength RF icon ( ) will appear on the main unit.
In the first few minutes of the RF reception, the main unit will show
data on one part of the screen and this is normal. The rest of the screen
display data will gradually appear in the next 10 minutes or more.
NOTE:
-If you have waited 1 hour or more without seeing the rest of the screen,
shorten the distance between the USB transmitter & main unit, check
the battery levels and repeat the setup procedure above.
-If it continues to fail, try removing the USB connection and all batteries
from the USB transmitter. Reinstall the batteries and then reconnect
the USB connection again. Repeat above procedure to set up the RF
connection.