1. Please Observe the Following
1.1.Safety
Do not touch the nozzle or molten adhesive with bare skin as they are hot - the operating temperature of the Loctite® Hysol® 175-SPRAY and 175-SPRAY-HT applicators is approximately 400ºF (200ºC). Protective gloves should always be worn. Careless handling can cause skin burns. If molten adhesive comes into contact with the skin immerse the affected area immediately in plenty of cold water. Seek medical advice if necessary.
In addition to the safety instructions herein, any statutory regulations, local fire insurance regulations, or other generally valid “regulations for accident prevention” must be complied with when using this tool.
•Never use the tool if it is damaged in any way.
•Do not use this tool in damp rooms, outdoors while it is raining, or where there is high humidity.
•Do not use this tool in the vicinity of any heat-sensitive materials, or any flammable materials, liquids, or gases.
•Only use extension cables that meet the specification shown in “Technical data”.
•Never pull on the tool’s connecting cable.
1.2.Items supplied
Loctite® Hysol® 175-SPRAY
Pneumatically-driven Hot Melt Cartridge Spray Dispenser, fitted with 356°F (180°C) thermostat (suitable for standard spray hotmelt adhesives)
Valve body airline adaptor Plastic Stand
Manual
Loctite® Hysol® 175-SPRAY-HT
Pneumatically-driven Hot Melt Cartridge Spray Dispenser, fitted with 383°F (195°C) thermostat (suitable for polyamide spray hotmelt adhesives)
Valve body airline adaptor Plastic Stand
Manual
2. Description
The Loctite® Hysol® 175-SPRAY and 175-SPRAY-HT are the highest output, hand- held industrial spray hotmelt applicators available. With its two powerful 250W stainless steel cartridge heaters, they are capable of dispensing up to 9 lbs. of molten hotmelt per hour, yet only take 10 minutes to warm up from cold.
Supported by a range of spray adhesive formulations, the Loctite® Hysol® 175-SPRAY and 175-SPRAY-HT are suitable for most applications - they can even be used with heat sensitive substrates such as expanded polystyrene and other plastic foams. Also, the Loctite® Hysol® 175-SPRAY and 175-SPRAY-HT system are solvent-free and non-toxic, so there are none of the environmental problems often associated with other spray adhesive applicators.
Designed to comply with world wide safety standards, the Loctite® Hysol® 175-SPRAY and 175-SPRAY-HT also feature a totally enclosed heater housing, and are fitted with thermal fuse protection.
