QUICK GUIDE: BUSHNELL IMAGEVIEW
CHECK CAMERA SETTINGS
Make sure the camera is set for high quality (“LQ” does not show on the LCD
TAKE A PHOTO (TIPS FOR BETTER QUALITY PHOTOS)
Holding the ImageView Monocular as steadily as possible with one or both hands , lightly press down the SHUTTER button using the flat end of a finger. Leaning against a wall, tree, etc. to brace yourself can also help insure the camera does not move as you take the photo.
USING THE IMAGEVIEW WITH YOUR COMPUTER
If your computer OS is Windows 98/98SE, first install the driver from the
4
OPERATING INSTRUCTIONS
TURNING THE CAMERA ON AND OFF |
|
Insert 2 AAA alkaline batteries as indicated on the inside of the battery compartment, located below |
|
the eyepiece on the rear of the monocular. Turn the camera on by pressing and holding the MENU |
|
button until the display comes on and the camera beeps. To turn the unit off, press and hold the |
|
MENU button until the display goes out. The camera will turn itself off automatically to save batteries |
|
if none of the buttons have been pressed for two minutes. |
|
FOCUSING AND TAKING A PICTURE |
|
You may prefer to roll down the rubber eyecup if you are wearing glasses. Aim the monocular at a light |
|
colored background, and adjust the diopter for your eye by rotating the eyepiece clockwise or counter- |
|
clockwise until the 4 thin black reticle lines in the center are as sharp as possible for your vision. Then |
|
rotate the main focus ring (around the front objective lens) until your subject is also in sharp focus. |
|
Press the SHUTTER button to take a new photo. To take photos of subjects at different distances, leave |
|
the eyepiece diopter set where you have it, and simply focus with the main focus ring. For best results, |
|
hold the ImageView as steady as you can, and lightly press down the SHUTTER button using the flat |
|
end of your finger rather than “punching” it with a fingertip. |
|
CHANGING OPERATIONAL MODES |
|
Pressing the MODE button briefly will cycle through several special camera modes and settings. A |
|
corresponding icon or symbol (indicated in parentheses below) will be displayed on the LCD for each |
|
mode as you cycle through them by tapping the MENU button, and blink unless you select or confirm |
|
it with the SHUTTER button (icon will stop blinking). If no button is pressed for more than 5 seconds, |
|
the camera will return to normal operation. The modes/settings are shown as you cycle through them |
|
in the following order: | 5 |
|