C. Crane CC Radio 2 Setting the Timer, Line OUT Jack, Imer Activation Switch, To SET the on IME

Models: CC Radio 2

1 32
Download 32 pages 59.66 Kb
Page 18
Image 18

Radio Operation

LINE OUT Jack

 

The red jack, labeled LINE OUT, is used to output the audio from the

CCRadio2 to another device such as a recorder, your home stereo, or

some other unit. To do this, you will need an 1/8" stereo patch cord.

Note: The LINE OUT jack differs from a headphone jack because the

volume level of a headphone jack varies depending on the volume of

the radio. The LINE OUT jack has a set line level so the volume is con-

sistent no matter what the position of the volume knob.

1) Plug your patch cord into the LINE OUT jack on the CCRadio2.

2) Plug the other end of the patch cord into the LINE IN or AUDIO IN

of the device you want to send the audio to and you will hear the

radio through the other source. You can still listen to the CCRadio2

while using the LINE OUT jack.

is for use with a recorder

imer Activation Switch

The black jack labeled with this symbol

that has a timer activated switch. You would use this switch if you want-

ed to do a timed recording. It is used in conjunction with the LINE OUT

jack. See your recorderʼs instructions to determine if this function will

work with your recorder.

 

SETTING THE TIMER

Please read this entire section carefully before you start. You must go through the 3 steps listed below without stopping. If you stop for more than 15 seconds, press and hold the Timer Button until

you hear a single beep. Then start at step one again.

Before you begin, program the stations that you will want to record into memory. Refer to page 11 for instructions on programming memory pre- sets. The timer has an ON TIME and an OFF TIME. You must set both in order for the timer to work correctly.

1)

Press and hold the Timer/Set Button until you hear a beep and see

STE

1: TO SET THE ON IME

2)

the word ON, the hour digit and TIMER flash on the display.

Use the Tuning Up/Down Buttons to set the hour, verifying that the

3)

time is set correctly for AM or PM as shown on the display.

Press the Timer/Set Button again so the minutes and the word ON

4)

and TIMER flash on the display.

Use the Tuning Up/Down Buttons to set the minutes.

Page 18

CCRadio2

Page 18
Image 18
C. Crane CC Radio 2 instruction manual Setting the Timer, Line OUT Jack, Imer Activation Switch, To SET the on IME