Explaining the Transmitter Keypad Buttons (continued)
Prog/Loc
Briefly pressing this button starts or stops Locate Mode (explained on page 10).
Locate
Transmitter Display Symbols:
The display stays on for 30 minutes after a button press. After 30 minutes with no button presses, the display shuts off.
Pressing any button will make the display turn back on.
Various symbols you might see in the Transmitter display are explained as follows:
(Numeric readout) – Appears in the middle of the display, this shows the chosen stimulation level. Adjust with the Stim level up / Stim level down (arrow) buttons.
– The left symbol displays when the Transmitter is controlling Dog Collar Receiver 1. You can purchase a second collar to expand the system for training two dogs. The right symbol displays when controlling Dog Collar Receiver 2. Switch between Collar Receivers by pressing the Dog Select button. Both symbols display when in Dual Dog mode. (See Set Dual Dog mode on page 7.)
–This symbol appears whenever Tone is part of the Stimulation type chosen. (See Program the Stim Type on page 7.)
– This symbol appears when the Transmitter is in programming mode. (See Programming Mode on page 7.)
– This symbol appears when the Transmitter is in Locate mode.
–The battery indicator
provides constant awareness of your battery’s power level. (See Battery Indicator on page 9.)
Backlight – The Transmitter features a backlit display. The display backlight stays on for 5 seconds after a button press.
USING THE TRANSMITTER
Turning ON the Transmitter
Power up the Transmitter by pressing any button. You will see the display turn on when you press any button.
Reset All Programmable Settings
Press 
and 
at the same time to reset all programmable settings to the default settings. The Transmitter Display shows all symbols for two seconds during reset.
Transmitter Default Settings
Dog 1&2 Primary Stim Level: 5
Dog 1&2 Stim Type: Stim without Tone
Dog 1&2 Primary Stim Level: 7
Dog 1&2 Alt Stim Level: 14
Set Stim Button Intensity Level
To change the intensity level for the Stim button:
Press 
or 
until the desired stimulation level is displayed. When the Stim button is pressed, the Receiver will deliver a stimulation at this setting.
Programming Mode
To enter Programming Mode, press and hold the Prog/Loc button until the PROG symbol displays, then release the button. The Transmitter is now in Programming mode.
To exit Programming Mode, press and release the Prog/Loc button again. The PROG symbol no longer displays.
Program the Stim Type (Tone Option)
For
without Tone.
To choose:
1.Choose desired dog. Press (Dog Select button).
2.Press t he P rog/Loc b utton u ntil t he PROG symbol shows in the Transmitter display. Release Prog/Loc button.
3.Press and release TONE. If you keep pressing the TONE button, the selection switches between these choices:
•Stim without Tone (no Tone symbol
displayed)
• Stim with Tone (Tone symbol displayed)
4.Press and release the Prog/Loc button to save setting and exit.
For additional information regarding using
the Tone, see Training Tone Option on
page 14.
Set Dual Dog mode
In Dual Dog mode, the continuous stimulation button (red) controls Dog 1 Collar Receiver, and the Momentary Stimulation button (gray) controls Dog 2 Collar Receiver. You control two dogs without using the Dog Select button to switch between dogs. In this mode, Stim
type is stim without tone.
|
|
|
|
|
|
6 | Cabela’s® Gun Dog® — Owner’s Manual | Cabela’s® Gun Dog® — Owner’s Manual | 7 | ||
