CHANNEL CONTROL
SOURCE SIDE
Method A: Push Button
1.Use the switch button on output port to select which port to be changed.
(+) increase
2.Push the switch button on Input channel. The source will be sequentially changed. After few seconds, the setting will be active.
Method B: IR Remote Control
a. Please press F1 to F8 Enter IR control mode and decide which output port to be controlled (see the table below), and wait a few seconds for the output port seven segment display to show the number of selected output port. Or you can use up (
) and down ( 
) button to enter IR control mode and select the output port in ascending and descending order respectively.
Note:
F1 |
| HDMI output port #1 | |
|
|
| |
F2 |
| HDMI output port #2 | |
|
|
| |
F3 |
| HDMI output port #3 | |
|
|
| |
F4 |
| HDMI output port #4 | |
|
|
| |
F5 |
| HDMI output port #5 | |
|
|
| |
F6 |
| HDMI output port #6 | |
|
|
| |
Enter ( | ) | HDMI output port #7 | |
|
|
| |
Exit ( | ) | HDMI output port #8 | |
|
|
| |
Up ( | ) | Switch output port in ascending | |
order | |||
|
| ||
Down ( | ) | Switch output port in descending | |
| |||
|
|
|
b. Use left ( 
) or right ( 
) button to select input source as indicated by the seven segment display on the front panel for the input channel. The setting will be active once the channel switch command is set after a couple seconds.
Note:
Right ( 
) button to switch input source in ascending order (1, 2, 3, 4, 5, 6, 7, 8, 1, ...)
Left ( 
) button to switch input source in descending order (1, 8, 7, 6, 5, 4, 3, 2, 1, …)
PANEL DESCRIPTIONS
1 | 2 | 3 | 4 |
1.Power: Power control
2.Seven Segment LED Indicators: Control display
3.Front panel push buttons: Used to input source and display channel number
4.IR: IR receiver
6 | 9 | 1 | 9 | 12 | 9 | 1 | 9 | 11 | 13 | 8 | 7 |
5.AC Power:
6.
7.USB: USB control port
8.SW Main: DIP switches (see DIP Switch section in p.8)
9.SW
10.INPUT 1
11.IR
12.OUPUT PORT
13.IR Main: 3.5mm IR blaster socket for HDMI source control on all 8 inputs [default socket for IR blaster]
