Cabletron Systems setup guide CSX500 Setup Guide, PRE-CONFIGURATION Information, Tools needed

CSX500 SETUP GUIDE

PRE-CONFIGURATION INFORMATION

Only qualified personnel should install the CSX500. This Setup Guide is intended for the experienced network equipment installer.

This Setup Guide describes the tools needed to configure the CyberSWITCH CSX500.

NOTE

For further details concerning the operation of the CSX500, refer to the HSIM-W84 documentation on the QuickSet CD. The HSIM-W84 is similar to the CSX500. The difference is that the HSIM-W84 is a module that is installed into a host device, while the CSX500 is a standalone unit. All other information pertaining to the device is the same.

Figure 1 shows the CyberSWITCH CSX500.

ENET

RX

TX

LAN

LNK

STS

ROUTER/SWITCH/INVERSE MUX

T1-1		T1-2		T1-3		T1-4
	LNK				LNK
			LNK
	STS		STS		STS
			TELCO

ASYNC

LNK

STS

CONSOLE

PWR

CPU

WAN BRANCH OFFICE CONCENTRATOR

Figure 1 The CSX500

QuickSet CONFIGURATION SETUP

Tools needed

The following tools are required to configure the CSX500:

•Personal Computer (PC)

•Read Me First! instruction sheet (enclosed in the manual package)

•QuickSet CD (located in the shipping box with your device)

NOTE

Cabletron Systems highly recommends using the QuickSet utility to configure the CSX500. Using the QuickSet CD will ensure a fast and correct installation. Using other methods may not produce correct or as efficient results as the QuickSet CD.

PN 9032534-03 Page 1 of 2