Husqvarna Comprehensive Guide to Repair and Adjustment for Your Tiller

5. Repair and adjustment	5. Reparatur und Einstellung
5. Réparations et réglages	5.	Herstellen en afstellen
5. Riparazioni e messa a punto		5. Reparación y ajuste

Eng 1. Handle (low position)

2.Handle (high position)

3.Handle lock lever

4.Belt guide

5.Engine pulley

6.Idler pulley

7.Extention spring

8.Transmission pulley

9.Drive control cable

10.Cable clip screw

Figure 16

Position handle

Loosen handle lock lever (fig. 16). Handle can be positioned at different settings between "high" and "low" positions (fig. 16). Retighten handle lock lever.

NOTE!

Select handle height suitable for you and your tilling condi- tions. Handle height will change when tiller digs into the soil.

WARNING!

Stop the engine and remove the spark plug wire and cover from the spark plug (fig. 7) before cleaning out the tines by hand. Use caution - tines are sharp.

CAUTION!

Place blocks under transmission to keep tiller from tipping.

Ground drive belt adjustment

For proper belt tension, the extension spring (fig. 17) should have about 5/8 inch stretch with drive control bar in engaged position (fig. 9). This tension can be obtained as follows.

2

a. Loosen cable clip screw securing the drive control cable (fig. 17).

b. Slide cable forward for less tension and rearward for more tension until about 5/8 inch stretch is obtained.

c. Tighten cable clip screw securely.

3

1 Figure 17

10

4

5

6	8
7

9

52