6
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Unfold the Frame
(50) away from the Uprights (73). Do not lean on
the Uprights.
Orient the Base (80) as shown. Attach the Base
to the Uprights (73) with four M10 x 65mm
Patch Screws (1). Start all four Screws, and
then tighten each of them.
Raise the Uprights (73) so that the Base (80) is
flat on the floor.
1
73
80
1
M10 x 65mm Patch Screw (1)–4
M10 x 45mm Screw (2)–4
4.2 x 19mm
Screw (3)–6 #10 x 1" Tek
Screw (83)–2
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
disposeof the packing materials until assembly iscompleted. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of
the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver , standard
screwdriver , and needlenose pliers .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: Some small parts may have been preassembled. To avoid dam-
aging parts, do not use power tools for assembly. Extra hardware may be included.
1
50