8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One of the hex keys is used to adjust the walking belt (see pages 17 and 18). To protect
the floor or carpet, place a mat under the treadmill.
5. Attach the Latch Housing (72) to the left Upright
(73) with two #10 x 1" Tek Screws (83); start
both Screws, and then tighten each of them.
Place the treadmill in the storage position (see
HOW TO FOLD THE TREADMILL on page 15).
7. Removethe Spring Clip (86) from the lower end
of the Gas Spring (85). Press the lower end of
the Gas Spring onto the Mount (82) on the
bracket in the center of the Base (80). Note: It
may be necessary to pivot the Frame (not
shown) forward or backward slightly (see HOW
TO LOWER THE TREADMILL FOR USE on
page 15).
See the inset drawing. Insert the Spring Clip
(86) into the two indicated small holes in the Gas
Spring (85). Rotate the Spring Clip until it clips
onto the Gas Spring.
Lower the treadmill. See HOW TO LOWER THE
TREADMILL FOR USE on page 15.
5
83
73
72
6. Identifythe rod end of the Gas Spring (85). See
the two small inset drawings. Locate the
Spring Clip (86) in the rod end of the Gas
Spring. Using your fingernail or a screwdriver,
press on the end of the Spring Clip to loosen it.
Rotate the Spring Clip, and then pull the Spring
Clip out of the Gas Spring. Avoid losing the
Spring Clip. Extra Spring Clips are included.
Next, press the rod end of the Gas Spring (85)
as far as possible onto the Mount (82) on the
bracket in the center of the Frame (50).
See drawing 6a. Insert the Spring Clip (86) into
the two indicated small holes in the rod end of
the Gas Spring (85). Then, rotate the Spring Clip
until it clips onto the Gas Spring.
85
86
50
50
86 85
82
Holes
Bracket
Rod
86
86
7
86
85
Bracket
8
6
6a
80 82
86
85
Holes
Bracket
80