Cadet 4F1000, 2F350 warranty The Cadet Electric Baseboard, Owner’S Guide, Important Instructions

Models: 8F2025 2F500-8 10F2500 8F2500 8F2500-8 6F1500 3F750-8 3F750 2F500 6F1500-8 5F1250 8F2000 2F350 4F1000 5F1250-8

1 12
Download 12 pages 57 Kb
Page 1
Image 1
The Cadet

The Cadet

Electric Baseboard

OWNER’S GUIDE

Features & Benefits

Oversized high temperature limit switch with full length sensor for added safety

Durable steel sheathed element with a limited lifetime warranty

Easy installation with pre-punc hed case at 1” intervals

Rugged steel construction

Thermos tat not included

240/208 VOLT MODELS

2F350 6F1500

2F500 8F2000

3F750 8F2500

4F1000 8F2025

5F1250 10F2500

208 VOLT MODELS

2F500-8 3F750-8 4F1000-8

5F1250-8 6F1500-8 8F2000-8

8F2500-8

120 VOLT MODELS

2F500-1 3F750-1 4F1000-1

6F1500-1

TOOLS REQUIRED

#2 Phillips

Drill Bits

Screwdriver

(4) Wood Screws

Straight

Wire Connectors

Screwdriver

(1) Strain Relief

Wire Strippers

Connector

 

Drill or Hammer

IMPORTANT INSTRUCTIONS

OWNER’S GUIDE WARNING!

Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock or tag the panel board door to prevent someone from turning on power while you are working on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.

1.Read all instructions before using this heater.

2.Read all information labels. Verify that the electrical supply wires are the same voltage as the heater.

3.All electric al work and materi als must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes.

4.The heater must be grounded to the grounding pigtail (copper wire) provided.

5.If you need to install a new circuit or need additional wiring information, consult a qualified electrician.

6.Protect electrical supply from kinks, sharp objects, oil, grease, hot surfaces or chemicals.

7.Do not place heater against paperboard or low-density cellulose fiberboard surfaces.

8.Do not place heater below an electrical convenience receptacle.

9.Features & Benefits WARNING

Overheatingor firemay occur.Do not install the heater behind doors.

10.IMPORTANT INSTRUCTIONS WARNING

Fire or explosion may occur. Heater has hot and arcing or sparking parts inside. Do not install heater in any area where combustible vapors, gases, liquids, or excessive lint or dust are present.

11.SAVE THESE INSTRUCTIONS WARNING

Burn Hazard. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use extreme caution when any heater is used by or near children or invalids and whenever the heater is left operating unattended.

12.Manual background WARNING Manual background

Risk of electrical shock. Keep all foreign objects out of heater. Do not operate after heater malfunctions or has been dropped or damaged in any manner.

13.Manual background WARNING

Risk of Fire. Do not block heater. Heater must be kept clear of

all obstructions: minimum of 12 inches in front and above, 6 inches on both sides. Heaters must be kept clean of excessive lint, dirt and debris. (See Maintenance Instructions)

14.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons.

SAVE THESE INSTRUCTIONS

www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675

Page 1
Image 1
Cadet 4F1000, 2F350 warranty The Cadet Electric Baseboard, Owner’S Guide, Important Instructions, Save These Instructions