Installation Instructions
STEP 2: Baseboard Wiring (continued)
Refer to the wiring diagram below that corresponds to your heater application.
For single wattage baseboards, refer to “Standard Baseboards.”
For model 8F2025, refer to
STANDARD BASEBOARD WIRING ON RIGHT SIDE
120V OR 240V SUPPLY (See Figure 8)
1.Connect one supply wire to one heater wire.
2.Connect remaining supply wire to remaining heater wire.
3.Replace wiring compartment cover and secure with screw previously removed.
4.Turn power back on at the electrical panel board.
To Supply | Figure 8 | |
Right Side | ||
Baseboard Heater | Wiring Shown | |
Supply Wires | ||
| ||
| Side ‘B’ Shown | |
| Ground |
STANDARD BASEBOARD WIRING ON LEFT SIDE
120V OR 240V SUPPLY (See Figure 9)
1.Connect one supply wire to one heater wire.
2.Connect remaining supply wire to remaining heater wire.
3.Replace wiring compartment cover and secure with screw previously removed.
4.Turn power back on at the electrical panel board.
To Supply |
| Left Side |
|
| Figure 9 |
Supply Wires | Baseboard Heater | Wiring Shown |
|
| |
Side ‘A’ Shown |
|
|
Ground |
|
|
MULTI-WATT BASEBOARDS: WIRING ON RIGHT SIDE
MODEL 8F2025 (See Figure 10)
1.Connect one supply wire to one heater wire.
2.Connect remaining supply wire to remaining heater wire.
3.Replace wiring compartment cover and secure with screw previously removed.
4.Selecting desired wattage
a.For 2500 watt applications: No action is required. Heater is factory set for 2500 watts.
b.For 2000 watt applications: Remove left wiring compartment cover. Cut red wire and cap both loose ends with approved wire connectors, or wrap both loose ends with electrical tape. Replace wiring compartment cover and secure with screw previously removed.
5.Turn power back on at the electrical panel board.
Figure 10
Right Side
Wiring Shown
|
| To Supply |
|
| Baseboard Heater |
Red | Red Wire | Supply Wires |
Wire |
| Side ‘B’ Shown |
|
| |
|
| Ground |
2000 Watt Configuration
Left Side of Baseboard Shown
MULTI-WATT BASEBOARDS: WIRING ON LEFT SIDE
MODEL 8F2025 (See Figure 11)
1.Connect one supply wire to one heater wire.
2.Connect remaining supply wire to remaining heater wire.
3.Selecting desired wattage
a.For 2500 watt applications: No action is required. Heater is factory set for 2500 watts.
b.For 2000 watt applications: Cut red wire and cap both loose ends with approved wire connectors, or wrap both loose ends with electrical tape.
4.Replace wiring compartment cover and secure with screw previously removed.
5.Turn power back on at the electrical panel board.
Figure 11
To Supply |
| Left Side |
Baseboard Heater | Wiring Shown | |
Supply Wires |
| |
|
| |
Side ‘A’ Shown | Red Wire | Red |
Ground | Red | Wire |
Wire |
| |
Model 8F2025 - |
|
|
Factory set for |
|
|
2500 watts |
|
|
2000 Watt Configuration
Left Side of Baseboard Shown
4