Infrared Music Maker™ Plus
Player/Recorder Owner’s Manual
2
Initial Setup
Visit us online at califone.com
AC Line Operation
1. The power cord is located at the rear of the unit. Release the cord retainer tab and uncoil the cord.
2. Plug the cord into a standard 120 volt 50-60 Hz AC outlet. Be sure the plug blades are fully inserted.
THE UNIT IS ON WHEN PLUGGED IN.
Battery Operation
1. The battery compartment is located at the rear of the unit. Push the lever at the center of the door toward the rear
of the unit and then lift the door free.
2. Eight “D” or UM-1 size batteries are required. When installing the batteries refer to the orientation diagram shown
inside the battery compartment. Place the batteries on top of the nylon ribbon. This helps to “pop” old batteries out
when you need to replace them.
3. Replace the battery cover.
IMPORTANT:
Remove all batteries from your cassette unit if it will not be used for an extended period of time.
DO NOT LEAVE DISCHARGED BATTERIES IN THE BATTERY COMPARTMENT. DAMAGE TO THE UNIT DUE TO BATTERY
CORROSION IS NOT COVERED UNDER WARRANTY.
NOTE:
Califone cassette recorders are designed for use only with 60-minute Type 1 Normal Bias recording tape.
califone_2395IR_manual.indd 5 9/14/07 4:34:44 PM