FRONT PANEL CONTROLS
azur 840A
Class XD Integrated Amplifier
8
Standby / On | Phones | Speaker A/B | Mode |
|
|
| Bass Treble | Direct | 11 |
|
|
|
| ||||||
1 | 2 | 3 | 4 | 5 | 6 | 7 | 9 | 10 | Volume |
|
|
1 Standby/On | 3 Speaker A/B |
Switches the unit between Standby mode (indicated by dim power LED) and On (indicated by bright power LED). Standby is a low power mode where the power consumption is less than 10 Watts. The unit should be left in Standby mode when not in use.
2Phones
Allows for the connection of stereo headphones with a ¼" Jack plug. Headphones with an impedance of between 32 and 600 ohms are recommended. When the headphones are connected, the loudspeaker relays are released switching off the output to the loudspeakers (speakers A and B).
Press to scroll through the speaker sets connected to the loudspeaker terminals on the back panel (speaker sets A, B or A and B). This can be used for listening to an extra set of loudspeakers in another room.
Please note that care should be taken when choosing speakers if two loudspeakers are going to be used on each channel. If the combined resistance measured on the loudspeaker terminals is too low the amplifier may not switch out of Standby mode until a suitable load resistance is detected. For more information refer to the CAP5 section of this manual.
Note: When using one pair of speakers, use speakers with a nominal impedance of between
8Azur Class XD integrated amplifier
