Cambridge Audio Azur 740A Operating instructions, Amplifier setup, azur 740A, Volume, Speaker A/B

Operating instructions

The 740A has a custom-made display on the front of the unit showing the current status and allowing you to access the 740A System Configure menus. Here you can adjust the listening settings of the amplifier to personal preference. The menu system is easy to navigate and control, simply by using the input select buttons to turn a feature on (solid circle) or off (no circle) and the volume control knob to increase/decrease settings.

Volume

Mode

Volume

Adjust the volume control knob on the front panel (or using the remote control). The display will show the change in volume in decibels (dB). ‘OdB’ indicates maximum volume while lower volume settings progress into the negative range. This can also be changed to volume units (0-72) in the System Configure menu.

Speaker A/B

Speaker A/B

Volume

Press the Speaker A/B button to scroll through the speaker sets connected via the rear panel: speakers A, B or A and B.

Balance

Mode

Volume

Press the Mode button to enter Balance mode. BALANCE will appear on the display and can be adjusted using the volume control. Press the Mode button again to return to Volume mode or wait 5 seconds for the 740A to automatically exit Balance mode.

Bass and Treble

Bass Treble Direct

These controls allow subtle adjustments to the tonal balance of the sound. Press to release and rotate to adjust (press back in when desired settings found). An icon appears on the display to show if Bass/Treble has been adjusted. In the central position these controls have no effect.

These controls only modify the sound through your loudspeakers and the Pre-Out sockets; they do not affect the signals sent through the Tape Out connections. With a well produced CD and a good system the tone controls are unnecessary and can be switched out by pressing the Direct button:

Bass Treble Direct

This completely removes them from the signal path for maximum fidelity. If the musical recording is of poor quality or other factors are affecting the sound quality, it may be necessary to adjust the tone controls to compensate.

azur 740A

Amplifier setup

The 740A features many advanced settings that allow it’s use to be customised to user preference. The inputs can be named to reflect the actual source units you have, each input can be trimmed so that each sounds the same in terms of loudness when you switch between them and other options.

Changing input names / source naming

Mode

Volume

Press and hold the relevant input select button for four seconds to change its name. For example, if Input 1 is a CD player, name it “CD” etc. Letters are selected by turning the volume control to scroll through the available characters. Press LEFT or RIGHT to select which character you wish to edit. Press EXT CHAR to access an extended character set. Press OK to confirm and exit the input name change menu.

System Configure menu

Mode

Volume

Press and hold the Mode button to access the System Configure menu. The first menu options are Input gain trim and Fixed input gain. Press MORE to access the second menu options of Clip detector, LCD brightness, Speaker short detector, Volume ramp and Volume display.

Mode

Volume

To exit the System Configure menu and its sub-menus, press the Mode button again.

Clip detector / Speaker short detector

Refer to the ‘CAP5’ section of this manual for more information on the Clip and Short detection features of the 740A, as both can be enabled (default) or disabled.

LCD brightness

Mode

Volume

In the System Configure menu press the LCD input select button to scroll through bright/dim/off settings for the front panel display. Press the Mode button to exit.

Volume ramp

Mode

Volume

The 740A automatically ramps the volume down when going into Standby mode and up when coming out of Standby mode. To turn this feature off, press the VOL RAMP input select button in the System Configure menu and set to off. Press the Mode button to exit.

ENGLISH

9