Front panel controls
azur 840W
Class XD Power Amplifier
1 |
| Left |
|
|
|
|
Standby / On | Output | Protection | Clipping | Bridged | Mono | Output |
| ||||||
| 2 | 3 | 4 | 5 | 6 | 2 |
1 Standby/On | LED indicators |
Switches the unit between Standby mode (indicated by dim power LED) | Stereo output: |
and On (indicated by bright power LED). Standby mode is a low power |
|
mode where the power consumption is less than 10 Watts. The unit |
|
should be left in Standby mode when not in use. |
|
When the 840W is switched out of Standby mode it will automatically check for faults and allow the power amplifier stages to stabilise before
Note: The protection LEDs will flash whilst this check is being done.
Mono output:
2Output
Indicates that the Left or Right output is active. The LED
3Protection
If this LED is constantly on the 840W has detected a fault on either the
Left or Right channel and is protecting itself.
4 Clipping | Bridged Mono output: |
This LED indicates that the 840W has detected that either the Left or
Right channel is being overdriven or clipped.
Clipping distortion is caused at high volume levels when the output signal attempts to go outside the maximum voltage that the connected
Clipping
When the 840W detects clipping this LED will briefly flash. If the clipping reaches a dangerous amount that could damage the amplifier or attached speakers the unit will then go into protection.
5Bridged
This LED indicates that the 840W is being used in Bridged mode. (The
Mono LED will also be illuminated.)
6Mono
This LED indicates that the 840W is being used in a Mono mode.
Right
Protection Clipping
34
azur 840W
Class XD Power Amplifier
Bridged Mono
azur 840W
Class XD Power Amplifier
Bridged Mono
azur 840W
Class XD Power Amplifier
Bridged Mono
6