Avoid placing the keypad where there is line of sight to another keypad. In such
situations both keypads may pick up the same commands from a remote
control and it will be difficult to control each zone independently.
Avoid placing the BK10 where there is line of sight to the source equipment for the
system. In such situations the source equipment may pick up the same IR
commands directly as are picked up by the keypad and sent to the source
equipment. This can interfere with the remote operation of the source equipment.
Do not place the keypad in areas directly lit by strong sunlight or where it will be
strongly lit by fluorescent tubes. These can be sources of infra-red energy which
can interfere with the remote control operation of the system. Some plasma
televisions can radiate a lot of infra-red energy and care should be taken if fitting
a BK10 near a plasma screen television. Avoid placing the BK10 near to dimmer
switches or other items, which generate a lot of electrical noise.
Safety precautions
The BK10 runs on 24V DC supplied through the connecting cable. As such
there is no mains voltage present in the BK10 and the unit is often safe to
place in areas where only extra low voltage (ELV) equipment is permitted.
However, it is imperative that you always check the wiring regulations in force
for your application and area.
INSTALLATION NOTES10 Incognito table-top keypad